Connecting to a Cluster
Connecting to a Cluster
See Huione Clusters for general information about the available clusters.
Configure the command-line tool
You can check what cluster the Huione command-line tool (CLI) is currently targeting by running the following command:
Use Huione config set command to target a particular cluster.
After setting a cluster target, any future subcommands will send/receive information from that cluster.
For example to target the Testnet cluster, run:
Ensure Versions Match
Though not strictly necessary, the CLI will generally work best when its version matches the software version running on the cluster.
To get the locally-installed CLI version, run:
To get the cluster version, run:
Ensure the local CLI version is greater than or equal to the cluster version.
Last updated